afx light 15-1817, Инструкция по эксплуатации

Страница: 2 / 19

© Copyright LOTRONIC 2016 FREEPARHEX Page 2
Thank you for having chosen our AFX LED WIRELESS BATTERY LIGHT . For your own safety, please read this user manual
carefully before installing the device.
SAFETY INTRODUCTION
“AC INPUT” is the charging interface. When charging, the fixture must be “Turn OFF”.
Lease do not work in the AC unless it’s under emergency
If it works in the AC for a long time, the charger and battery of the fixture will overwork,
Bring out a lot of heat and cause a risk of explosion.
If the battery runs out, then connect to the AC. It needs 10mn to recover to the normal operation.
When in the outdoor, please not use AC to operate the fixture. The waterproof and dustproof rate of the fixture is IP44.
Please avoid the leakage of electricity and the danger of electric shock.
SAFETY INTRODUCTION

If the device has been exposed to temperature changes due to environmental changes, do not switch it on immediately. The arising
condensation could damage the device. Leave the device switched off until it has reached room temperature.

It is essential that the device is earthed. A qualified person must carry out the electric connection.

Make sure that the available voltage is not higher than stated at the end of this manual.

Make sure the power cord is never crimped or damaged. If it is damaged, ask your dealer or authorized agent to replace the power cord.

Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the power cord by plug. Never pull
out the plug by tugging the power cord.

DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall
remain readily operable.

Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to such an extent that their effectiveness is
impaired, for example by cracks or deep scratches.
CAUTION:
1. Be very careful during installation. Since you will be working with a dangerous voltage you can suffer a life-threatening electric shock
when touching live wired.
2. Never look directly into the light source, as sensitive persons may suffer an epileptic shock.
3. Please be aware that damages caused by manual modifications to the device are not subject to warranty. Keep away from children and
non-professionals.
4. The light doesn’t include any spare parts for repair, please check if all the parts are well installed and screws are fitted tightly before
operating. Do not use the light when the cover is open.
GENERAL GUIDELINES

This device is only allowed to be operated with an alternating current of max. 100-240VAC and was designed for indoor use only.

Do not shake the device. Avoid brute force when installing or operating it.

When choosing the installation spot, please make sure that the device is not exposed to extreme heat, moisture or dust. The minimum
distance between light-output from the projector and the illuminated surface must be more than 1 meter. Keep a distance to any
flammable objects of at least 5m.

Operate the device only after having familiarized yourself with its functions. Do not permit operation by person not qualified for
operating the device. Most damages are the result of unprofessional operation.

Please use the original packaging if the device is to be transported.

For safety reasons, please be aware that all modifications on the device are forbidden. Furthermore, any other operation may lead to
short-circuit, burns, electric shock, lamp explosion, crash, etc. If this device will be operated in any way different to the one described in
this manual, the product may suffer damages and the guarantee becomes void.
GB