© Copyright LOTRONIC 2018 FOG1500W-T
Page 5
04
0 0 0 0 0 0 1 0 0
05
0 0 0 0 0 0 1 0 1
06
0 0 0 0 0 0 1 1 0
07
0 0 0 0 0 0 1 1 1
08
0 0 0 0 0 1 0 0 0
----
--------------------
509
1 1 1 1 1 1 1 0 1
510
1 1 1 1 1 1 1 1 0
511
1 1 1 1 1 1 1 1 1
The following points have to be considered during the inspection:
All screws for installing the devices or parts of the device have to be tightly connected and must not be corroded.
There must not be any deformations on the housing, glass pane, fixations and installation spots.
The electric power supply cables must not show any damage, material fatigue or sediments. Further instructions
depending on the installation spot and usage have to be adhered to by a skilled installer and any safety problems
have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or solvents.
CAUTION
: Disconnect from mains before starting maintenance operation!
CLEANING AND USING FREQUENCY OF PRODUCT
Please clean the fog machine periodically in order to keep it in good condition.
1- The fog liquid should be clear and not polluted. The bottle cap should be screwed tightly after filling in of the fog
liquid.
2- When the fog machine worked 40 hours continuously, please use 80% of distilled water and 20% of white
vinegar to clean the impurities which accumulated inside the heating tube
3- Remove the nozzle before the fog machine is warming up. Use vinegar to clean it and keep clear
4- Pour out the fog liquid and fill the tank with the distilled water/vinegar mix as above. Switch on the power and the
machine will warm up.
5- Operate the fog machine at open place until the distilled water/vinegar mix has been used up. Fill the unit again
with fog liquid and operate it at an open place until the vinegar smell has disappeared.
6- Others instructions :
a. Fog machines may jam easily because of impurities in the fog liquid. Therefore, a periodical
maintenance will lengthen the life time of the machine.
b. Please use a dry cloth for cleaning, please keep clear the machine when you store it.
TROUBLESHOOTING
Problem
Solution
Fog machine doesn’t spray
1. Check if the fog liquid has used up
2. Check if the nozzle is jammed
3. Check if the pump doesn’t work
4. Check if the thermocouple or thermostat is broken
Smoke output reduced
1. Check if the nozzle is jammed by impurities
2. Check if the pump power is weakened
Fog machine with peculiar smell
Immediately power off the machine and check if the
heater is melted
