AFM LX-150, Руководство пользователя

Страница: 135 / 246

Operation 135
4510001 REV B - 220620
Loading a Recipe
Labeling requires a significant amount of setup within the software for each unique product
labeling situation. To save time, this is accomplished using preset label “recipes.” Recipes for
your specific needs have likely already been created for you by AFM or by your distributor. New
recipes that are within the general specifications of your existing ones can be created by:
Before labeling, the correct recipe needs to be selected for the labels being used and the
product being labeled. This section provides basic setup instructions and assumes that recipes
have already been created for your specific labeling needs. For more detailed setup information,
read the “Software” section, starting on page 77 .
Items Needed to Load and Test a Recipe:
•
Ruler
To Load and Test a Recipe:
Power on the LX-150 (see “Powering the System On” on page 133 ).
Position the Cutter Blades (see “Positioning the Cutter Blades” on page 117 ).
Ensure that the desired film is properly loaded on the UR-1 and threaded through the
system. If it is not, load and thread a roll of the desired film (see “Installing the Film” on
page 119 and “Threading the Film” on page 121 ).
On the label film, use the Ruler to measure the length (in mm) of one label from the
beginning of one cut area to the beginning of the next cut area.
Check that the height of the Head Assembly is correct. The bottom of the Mandrel
should be half a label length above the top of a bottle on the Conveyor. If needed, adjust
the head height (see “Fine-Tuning the LX-150 Position” on page 60 ).
Label Length Cut
Area
Cut
Area