AFM LX-150, Руководство пользователя

Страница: 108 / 246

108 Software
4510001 REV B – 220620
Notice: No Catch Mark
The Print Reading Sensor is not seeing the cut area in the label film.
To Address the Fault and Resume Labeling:
Press the “Buzzer Stop” Button.
Make sure that film is threaded through the system. If there is no film load a new film
roll and thread it through the system (see “Installing the Film” on page 119 ,
“Threading the Film” on page 121 , and “Fine-Positioning the Film for Cutting” on
page 128 ).
On
Setting Screen 1
, confirm that the “Cut Length” is within the acceptable range
(40 – 250 mm). Assigning too short a “Cut Length” can trigger this alarm.
Check for a film jam. Starting at the bottom of the Mandrel, check the entire length of
the film path for kinks, wrinkles, tangles, twisting, obstructions, unusual wear, etc.
and correct any issues found.
Check that the Film Drive Wheels are not too tight against the Film Drive Bearings
(impairing the film’s ability to move through easily), or that the Film Drive Wheels are
not too far from the Applicator Bearings (preventing them from advancing the film
with precision). If needed, adjust the position of the Film Drive Wheels (see “Film
Drive Wheels: Unlocking/Adjusting/Locking” on page 112 ).
Check the Print-Reading Sensor Lens for any obstructions such as dust, dirt, or
cloudiness. If needed clean the Lens (see “Cleaning the Print Reading Sensor” on
page 150 ).
Check the Print-Reading Sensor’s sensitivity (see “Checking and Adjusting the Print
Reading Sensor’s Sensitivity” on page 179 ) and if needed, adjust it.
After the issue has been resolved, press the “Faut Reset” Button.
Press the “Exit Button.”