23
For Technicians | AfiPass II Installation Guide
To insert a cable into the controller:
1.
Puncture the plug using a small screwdriver or any pointed object. Pull the loosened plug out
of the grommet.
Caution: Remove a plug only where a cable will replace it. If grommet holes are left open, the
box will not be waterproof, and components may be damaged.
2.
Unscrew the nut and remove the grommet.
3.
Thread the cable through the nut, and then through the grommet hole. Allow slack for wiring
inside the box, allowing the box to open and close.
4.
Insert the grommet into the socket.
5.
Ensure the three small slots on the grommet are aligned with the pins in the cable inlet. This
prevents the grommet from rotating when the nut is tightened. Rotate the nut one revolution
on the threads, so that it is loosely held in position.
6.
After inserting cables, connect the wires as described in the following section.
