Afag UG 20 NC, Инструкции по монтажу и обслуживанию

Страница: 9 / 36

UG 20-UG 25-OI-vers. 3.5 gb. 20190409 9
2.1.4 Tightening torques for bolts
The screws to be used for assembly must at least satisfy the following conditions:
Standard:
VDI 2230
Strength: class 8.8
Surface: galvanized blue, oiled or greased
Thread Tightening moments
M3 1,1 … 1,4 Nm
M4 2,6 … 3,3 Nm
M5 5,2 … 6,5 Nm
M6 9,0 ... 11,3 Nm
M8 21,6 … 27,3 Nm
This is an incomplete machine
Assembly of the UG Universal gripper in a system
The series of the UG Universal gripper is used for the linear, smooth movement of
rigidly mounted loads under the ambient and Installation conditions defined for this
module, see Technical data. The UG Universal gripper can be installed in the
horizontal or vertical position.
NOTE
These Montage Instructions should be read carefully before carrying
out any activity on or with the UG Universal gripper. The UG
Universal gripper may only be deployed in accordance with the
intended use.
NOTE
Safety instructions
Modifications on the UG Universal gripper that are not described in
these Montage Instructions or have not been approved in writing by
Afag Automation AG are not permitted. In case of improper changes
or assembly, installation, operation and maintenance or repairs Afag
rejects all liability.