Afag SE20, Руководство по сборке и эксплуатации

Страница: 46 / 56

Maintenance and repair
46 – 56 Assembly instructions EN

SE20 - SE30

Date 06.09.2021

Version 2.0
9.3.1 Overview of the maintenance points
Fig. 13 Maintenance rotational axis (exemplary SE30)
No. Maintenance point Maintenance work
Interval
System
[On/Off] Remarks
1
Rotational axis
Cleaning and
checking
As required [Off]
-

Clean the rotational axis with a dry, lint-free cloth.
- Do not spray the rotational axis with water, do not use
aggressive cleaning agents.
- Perform a visual inspection of the axis.

Check screws for tight fit.
2
Total rotational axis
check
As required [On]
- Acoustic check for unusual noise development (in case of
unusual displacement movements or hard knocks,
eliminate malfunction immediately).
3
Lubrication points
Lubricating
Every year [Off]

Chap 9.3.2

Lubrication: If necessary, press in grease (Klübersynth UH1
14-31) via the fluid connections using a grease gun.
9.3.2 Lubrication
NOTICE
Risk of damage due to improper lubricants!
Do not use lubricants with additives such as MoS
2
, graphite or PTFE. These
lubricants can damage the module!

Only use the lubricants recommended by Afag in the maintenance table

chapter 9.3.1 or equivalent lubricants!
Fluid