Afag SE20, Руководство по сборке и эксплуатации

Страница: 31 / 56

Installation, assembly and setting
Assembly instructions EN

SE20 - SE30

Date 06.09.2021

Version 2.0 31–56
6 Installation, assembly and setting
The rotational axis is an incomplete machine. For safe operation, the module
must be integrated into the safety concept of the system in which it is installed.
During normal operation, it must be ensured that the user cannot interfere with
the working area of the rotational axis. This can be achieved through suitable
protective measures (e.g., enclosure, light grid).
When the system is running in special operating modes, it must be ensured that
there is no danger to the operator.
The system operator is responsible for the installation of the rotational axis in
a system! No warranty will be granted for damage caused by improper
installation on the part of the operating company.
6.1 Safety instructions for installation and assembly
Also observe the safety instructions in

chapter 2 „Safety instructions“ in this
manual.
6.2 Assembly and attachment
6.2.1 Mounting material
The accessories depend on the rotational axis used as well as the adapter
and weight.
Fig. 8 Accessories (mounting material)
NOTICE
Risk of damage due to incorrect installation!
Incorrect installation can damage the module.

Only use original LinMot cables for the connection.
Module Recommended mounting material
SE20

2/4x O-ring 2.5x0.62 NBR70

4x cylindrical pin DIN 6325 4m6x10

6x M4 screw (note screw-in depth)
SE30

2/4x O-ring 2.5x0.62 NBR70

4x cylindrical pin DIN 6325 4m6x10

2x Ø9h6 centring b 4x screw M6x20

2x Ø7h6 centring b 4x screw M4

2x Ø8h6 centring b 4x screw M3