Installation, assembly & setting
42 – 56
Assembly instructions EN
CR 25 / CR 32
Edition 01/2020
Rev. 4.0
6.3.3 Setting of the end positions
The exact setting of an end position depends on the stop sleeve, the shock
absorber and the adjusted compressed air.
Fig. 20
Exemplary illustration
To set the end positions proceed as follows:
1. Compressed air at P1: Flange rotates clockwise.
2. Loosen the clamping screw of the of the stop sleeve (Fig. 20, 3).
3. Turn the hexagon of the stop sleeve (Fig. 20, 2) until the end position is
correctly adjusted.
4. Compressed air at P2: Flange rotates counter-clockwise.
5. Turn the hexagon of the stop sleeve (Fig. 20, 2) until the desired end position
is reached.
6. Tighten the clamping of stop sleeves with the clamping screw (Fig. 20, 3).
The end positions are set.
6.3.4 Setting of the end position damping
To adjust the end position damping proceed as follows:
1. Loosen the hexagon nut (Fig. 20, 4) on the shock absorber.
2. Screw in or out both shock absorbers (Fig. 20, 1) with the small hexagon:
- the damping becomes harder when screwed in
- the damping becomes softer when screwed out
The end position damping is set.
If the damping function is not yet optimal, it can also be adjusted with a
compressed air throttle.
P2
P1
1
3
2
4
