AEV PROCAL, Руководство пользователя

Страница: 11 / 20

3. Insert the ProCal.
4. When the module is ready to start, the Electronic
Throttle (ETC) Indicator (a lightning bolt surrounded
by two vertical lines) will flash on the dash.
5. To start the pedal routine, pull the headlight stalk
back into the “Highbeam Flash” position, then
release the headlight stalk allowing it to fall back
into the “Highbeam Off” position. Just as if you
were flashing another vehicle. The routine has now
started.
6. Press the pedal forward all the way to the floor.
7. Move the headlight stalk forward to the “Highbeam
On” position.
8. Release the pedal back completely.
9. Pull the stack back to the “lowbeam” position.
10. With proper timing, the horn should now honk twice.
11. Turn the ignition off. Then start the engine. Test the
pedal and verify that it is functioning properly. If not,
repeat.
12. It may take multiple attempts.
NEW POWERTRAIN CONTROL MODULE (PCM) SETUP
(AEV HEMI ONLY)
Description: This mode allows the user to program the
vehicle’s VIN number into a new Powertrain Control
Module (PCM). When installing an AEV HEMI Builder’s
Kit with a new PCM, the new module will need to be
initialized and paired with the vehicle’s VIN in order for it
to function properly.
• After setting the ProCal module’s DIP switches
to this mode, no further input is required from
the user. The module will determine the vehicle’s
VIN and initialize the new PCM accordingly. After
programming, the vehicle will need to be cycled
Off, then On.