Aerus LAUNDRY PRO, Руководство пользователя

Страница: 6 / 32

6
This appliance must be installed in a level,
horizontal configuration as shown.
Do not install
the unit vertically, below the top of the washer
or at an angle
Failure to follow these instructions
may prevent the internal moisture sensor from
operating properly.
CAUTION:
INSTALLATION OF WALL ANCHORS OR SCREWS
A. If using supplied wall anchors, drill two 3/16” diameter holes.
Place two wall anchors into the wall. Install two supplied
screws and tighten until almost all the way in.
B. If mounting to wall studs, drill two 3/32” diameter holes
approximately 1” deep. Install two supplied screws and
tighten until almost all the way in.
16” OC
Keyholes
NOTE:
Washing machine and cold water faucet must
be within 4 feet of the right side of unit.
Level and place the Laundry Pro to the wall
and mark where the two (2) keyholes are on
each side with a pencil.
Screws (not shown)
Position the keyholes of the Laundry Pro onto the screws
(not shown). Finish tightening screws enough to securely
mount unit, but still allowing it to be removed from wall.
Remove unit from wall.
1
2