TRANSMITTER
T
A
TRANSMITTER INSTALLATION WITH ROBÒ SELF CLEANING BASE
1 - removing battery
(C)
inside transmitter
(T)
2 - put the transmitter
inside the lodging
(G)
3 - inserting support
(D)
and lock
the transmitter .
4 - fix support
(D)
at the base
through the screw
(H)
.
Transmitter
(T)
turns on and off the
central vacuum unit when ROBÒ
positions itself on self-cleaning base
to start the emptying phase of its dust
container.
G
H
T
D
WIRELESS AND MICRO LINE CONNECTION
Open the power unit’s electric
connection casing.
Reinsert the LM1 micro line connector into its
dedicated inlet and insert the other cable end into
the hole together with the one from the LM2 line.
Disconnect the micro line connector LM1, remove the
wire press from the hole and remove the cable.
Insert the new wireless cable in the free hole and
connect it to the dedicated LM2 plug inlet.
Insert the wire press with both lines, LM1 and
LM2, into the hole, close the casing and complete
the connection to the socket line.
Insert the endless end into the wire press where
the wireless cable was already inserted.
LM1
LM2
LM1
SETTING BETWEEN TRANSMITTER AND RECEIVER
H
S
K
RECEIVER
ELECTRONIC CARD
1
- check that the connection between the receiver
(R)
and the central vacuum unit is correct.
2 - unscrew the aerial and open the receiver
(R)
3
- remove the electronic card
(S).
4 -
press the button
(H)
, the LED will switch on
(K)
.
5 -
press the start button
(A)
of the transmitter
(T)
within 5 seconds
6 -
wait a few seconds for the memorisation of the new signal
7 -
close the receiver
(R)
and rescrew the aerial.
The setting has been completed. Whenever the transmitter button
(A)
is pressed, the
central vacuum unit will switch on.
The central vacuum unit and the wireless receiver must remain connected to the power supply
The wireless receiver is powered by 12 volts so no electrical hazard risk exists.
R
RECEIVER
THE SETTING BETWEEN TRANSMITTER AND THE RECEIVER IS ALREADY SET BY THE MANUFACTURER
Via Cerchia di S. Egidio, 760
47521 Cesena (FC) Italy
AERTECNICA S.P.A.
Tel. +39 0547 637311
Fax +39 0547 631388
www.aertecnica.com
1- Disconnect the power line of
the central power unit.
2 - Unscrew the aerial and open the
receiver
(R)
, remove the electronic
card and press the button
(H)
.
3 - While still pressing the button
(H)
, reconnect the power to the unit.
4 - The LED
(K)
will switch on.
5 - Release the button
(H)
.
6 - When the LED
(K)
switches
off, the receiver memory has been
deleted.
R
H
K
DELETING SAVED PROGRAMMES
Once the receiver memory has
been deleted, to reprogramming
the transmitter follow the
previous procedure.
T
C
Lithium battery
3V (CR2032)
4
1
5
2
6
3
