Aerpro AERA10D, Руководство по установке

Страница: 11 / 24

Using a Double DIN Dash Kit:
Radio chassis mounts to the kit brackets in the sub-dash, not to the kit main frame
4B
FIG. K
5. Determine the desired position of the display:
a. Display can be vertical or tilted up (FIG. K)
b. Display can slide up or down (Page 7)
c. Display can be tilted horizontally (Page 7 – FIG. B)
6. Determine the final front to back position by
measuring the shortest distance between the
display to the dash kit main frame or the factory
dash and subtract that distance/measurement by
~6.35mm
Note: Do not push the display all the way up
against the dash. Leave enough bottom gap as
the display's bottom edge rotates towards the
dash.
7. Remove the display from the bracket
assembly by pushing up from compression
spring side (1) and swing out to unhook top (2).
(FIG. L)
8. Remove the radio module & mounting
bracket assembly from the vehicle. Using the
measurement taken in step 6, slide the radio
module & bracket assembly back to that
distance.
FIG. J
4. Attach the display to the mounting bracket
assembly by hooking bottom spring hook and
then pushing up and hooking top hooks.
(FIG. J)
11
PROCEED TO STEP 5
on Page 16
1
2
HOOK BOTTOM
FIRST, THEN TOP
NOTE: BOOT AND DASH KIT NOT SHOWN
VERTICAL TILT: Use Hole A for no vertical
tilt or Hole B for 8 degrees of vertical tilt.
Insert a M5 X 10 on each side of the clamp
assembly at desired tilt.
A
M5 X 10
M5 X 10
B
1
2
FIG. L
Compression Spring