TAIL WHEEL
1)
Locate tail wheel steering hard point towards bottom of rudder. Drill a hole big enough for 4-40 rod
to slide through.
2)
Slide rod through rudder center rod and epoxy in place. Attach strip aileron horns to ends of rods.
Make sure rod sticks out 1” on each side.
3)
Use springs to attach tail wheel to strip aileron horns
4)
You may also mount rudder servo in the tail and use the 4-40 rudder push rod for tail wheel steering.
To do this, use one strip aileron horn and a 4-40 pushrod with a solder on clevis as shown.
Epoxy in place
Strip aileron horn
CANOPY/HATCH INSTALLATION
1)
For your convenience, your canopy has been pre cut and trim painted to fit the hatch cover.
2)
Trial fit canopy to hatch cover. Do all painting/prep work, dash panels and pilot installation prior to
gluing canopy.
Note:
We recommend you remove the covering from the cockpit floor location. We
use an automotive trunk spatter spray paint (Grey) and paint the floor location to complete a finished
look.
3)
Glue canopy to hatch cover. We recommend using canopy glue.
ENGINE / COWL INSTALLATION
It is first recommended to install engine per manufactures recommendations.
Engine thrust line is
1 ¾”
down from top of fuse box sides. 2 degrees of right thrust and 0 degrees of
down thrust. It will be necessary to offset the engine to the left (pilot view)
3/8”
to compensate for right
thrust. This will allow the center of the engine to exit at the center of the cowl.
9
Содержание Katana S
Страница 1: ...29 KATANA ARF ASSEMBLY MANUAL ...
