AeroWorks BD-5B ELECTRIC ARF, Инструкция по сборке

Страница: 8 / 34

COVERING
8
1. Open your kit slowly and take care not to damage
any parts of the kit. Remove all parts from their
plastic protective covers for inspection. Before
doing any assembly or installation of any decals
it is very important to re-shrink or re-tighten the
factory applied covering. Due to shipping, heat
and humidity changes from different climates,
the covering may become lose and wrinkle in the
sun. If you take the time to re-tighten the
covering, you will be rewarded with a long
lasting beautifully covered model.
2. Using your covering iron with a soft sock, gently
apply pressure and rub in the covering. If any
bubbles occur, your iron may be to hot. Reduce
heat and work slowly. If bubbles persist, use a
small pin to punch holes in the bubble to relieve
trapped air and reheat.
3.
Warning! If you use a heat gun, do so with
extreme caution. Take care not to apply too
much heat to any area for long periods of time.
This may cause the trim colors to over shrink and
pull away leaving unsightly gaps on the color
lines. The red and blue lines are especially
vulnerable to over heating and over shrinking.