Aerotech XC2, Руководство по оборудованию

Страница: 25 / 88

XC2 Hardware Manual Chapter 2: Installation and Configuration
Chapter 2: Installation and Configuration
2.1. Input Power Connections
The XC2 has two DC input power connectors. One connector is for control power and the other connector is
for motor power. For a full list of electrical specifications, refer to
Section 1.1.
DANGER : The 0V supply inputs must be connected to the protective ground at the external
power supply for your safety and to prevent damage to the equipment.
2.1.1. Control Supply Connector
The Control Supply input supplies power to the communications and logic circuitry of the XC2 . The +24V
input is connected to an internal fuse. Refer to Table 5-2 for the internal fuse value and part number.
For CE compliance, Aerotech recommends that you add a ferrite filter as close as possible to the XC2.
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply Connector Wiring Specifications
Pin Description Recommended Wire Size
(2)
+24 V 24 VDC (±10%) Control Power Input (48 Watt Max)
0.5 mm
2
(#20 AWG)
0 V
Control Power Common Input
(1)
0.5 mm
2
(#20 AWG)
Protective Ground (Required for Safety) 0.5 mm
2
(#20 AWG)
(1) For an isolated DC supply, connect 0V to protective ground at the supply.
(2) It is the user's responsibility to properly size external wires.
Table 2-2: Mating Connector Part Numbers for the Control Supply Connector
Type Aerotech P/N Third Party P/N
Screw Torque
Value: N·m
Wire Size:
mm
2
[AWG]
3-Pin Terminal Block ECK02456 Phoenix 1839610 0.22 - 0.25 2.5 - 0.05 [14-30]
www.aerotech.com 25