![Aerotech Soloist CP 10 Скачать руководство пользователя страница 52](http://html1.mh-extra.com/html/aerotech/soloist-cp-10/soloist-cp-10_hardware-manual_2863050052.webp)
52
Chapter 2
www.aerotech.com
2.3.2. Hall-Effect Interface (J103)
The Hall-effect switch inputs are recommended for AC brushless motor commutation but not absolutely
required. The Hall-effect inputs accept 5-24 VDC level signals. Hall states (0,0,0) or (1,1,1) are invalid and
will generate a "Hall Fault" axis fault.
Refer to
for Hall-effect device phasing.
Table 2-19:
Hall-Effect Feedback Interface Pins on the Motor Feedback Connector (J103)
Pin#
Description
In/Out/Bi
1
Chassis Frame Ground
N/A
3
+5V Power for Encoder (500 mA max)
Output
5
Hall-Effect Sensor B (brushless motors only)
Input
10
Hall-Effect Sensor A (brushless motors only)
Input
11
Hall-Effect Sensor C (brushless motors only)
Input
21
Signal Common for Encoder
N/A
Figure 2-25:
Hall-Effect Inputs (J103)
Soloist CP
Installation and Configuration
Содержание Soloist CP 10
