Aerotech Nmark SSaM, Руководство пользователя

Страница: 22 / 58

Installation and Configuration Nmark SSaM Hardware Manual
2.2. Power Connections
The Nmark SSaM has one AC input power connector. For a complete list of electrical specifications, refer to
Section 1.1.
2.2.1. Control Supply Connections (TB109)
The control power supply requires a minimum of 85 VAC input to operate properly. The AC1 input is
internally fused. The AC2 input is not internally fused but can be connected to a voltage source other than
Neutral if an external 2 A time-delay fuse is used.
Although the control power supply contains an internal filter, an additional external filter located as close as
possible to the Nmark SSaM may be required for CE compliance (Aerotech recommends Schaffner
FN2080).
Figure 2-1: Control Supply Connections
Table 2-2: Control Supply Input Wiring (TB109)
Pin Description Recommended Wire Size
AC1 Line Input: 85 - 240 Volt AC Input Range 1.3 mm
2
(#16 AWG)
AC2 Neutral (0V) or 85 - 240 Volt AC Input Range with external fuse 1.3 mm
2
(#16 AWG)
Protective Ground (Required for Safety) 1.3 mm
2
(#16 AWG)
N O T E : Wire insulation rated for 300 V.
Table 2-3: Control Supply Mating Connector (TB109)
Type Aerotech P/N Phoenix P/N
Screw
Torque
Value: Nm
Wire Size:
mm
2
[AWG ]
3-Pin Terminal Block ECK00213 1754465 0.5 - 0.6 3.3 - 0.516 [12-30]
22 Chapter 2 www.aerotech.com