Aerotech Automation1 iXC2, Руководство по оборудованию

Страница: 27 / 96

Chapter 2: Installation and Configuration
The sections in this chapter include details on how to set up the electrical and safety components of
your system. Obey all safety warnings, including those in
Safety Procedures and Warnings .
2.1. Input Power Connections
The drive has two DC input power connectors. One connector is for control power and the other
connector is for motor power. For a full list of electrical specifications, refer to
Section 1.1. Refer
to Section 2.6. for a System Interconnection Drawing.
2.1.1. Control Supply Connector
DANGER: Shock and Fire Hazard
Electrical wiring must be designed and installed in accordance with local electrical
safety regulations to prevent the risk of fire and electrical shock.
The Control Supply input supplies power to the communications and logic circuitry of the drive . The
+24V input is connected to an internal fuse. Refer to Table 5-4 for the internal fuse value and part
number. For an isolated DC supply, connect 0V to protective ground at the supply. Use twisted pair
wiring to minimize radiated noise emissions (refer to Figure 2-1 ).
Figure 2-1: Control Supply Connections
Table 2-1: Control Supply Connector Pinout
Pin Description
+24 V
24 VDC (±10%) Control Power Input
(2 A max, 0.4 A typical without brake)
0 V Control Power Common Input
Protective Ground
Table 2-2: Control Supply Mating Connector Ratings
Specification Description
Type 3-Pin Terminal Block
Part Numbers
Aerotech: ECK02456
Phoenix: 1839610
Conductor Cross
Section
One conductor, stranded with ferrule
and plastic sleeve
18...22 AWG (0.25...0.75 mm 2 )
Two conductors (same cross-
section), stranded , twin ferrule with
plastic sleeve
20 AWG (0.5 mm
2
)
Tightening Torque 0.22...0.25 N·m
Conductor Insulation Strip Length 7 mm (0.25 in)
(1) Refer to the manufacturer website for additional information.
Hardware Manual iXC2/XC2
www.aerotech.com 27