Aerotech Automation1 iXC2, Руководство по оборудованию

Страница: 86 / 96

5.1. Preventative Maintenance
Do an inspection of the iXC2/XC2 and the external wiring one time each month. It might be
necessary to do more frequent inspections based on:
l
The operating conditions of the system.
l
How you use the system.
Table 5-3: Preventative Maintenance
Check Action to be Taken
Examine the chassis for hardware and parts
that are damaged or loose.
It is not necessary to do an internal inspection
unless you think internal damage occurred.
Repair all damaged parts.
Do an inspection of the cooling vents. Remove all material that collected in the vents.
Examine the work area to make sure there are
no fluids and no electrically conductive
materials.
Do not let fluids and electrically conductive
material go into the chassis.
Examine all cables and connections to make
sure they are correct.
Make sure that all connections are correctly
attached and not loose.
Replace cables that are worn.
Replace all broken connectors.
Cleaning
DANGER : Before you clean the iXC2/XC2, disconnect the electrical power from the
drive.
Use a clean, dry, soft cloth to clean the iXC2/XC2. If necessary, use a cloth that is moist with water or
isopropyl alcohol. If you use a moist cloth, make sure that moisture does not go into the drive. Also
make sure that it does not go onto the outer connectors and components. Internal contamination
from the cleaning solution can cause corrosion and electrical short circuits.
Do not clean the labels with a cleaning solution because it might remove the label information.
5.2. Fuse Specifications
WARNING : Replace fuses only with the same type and value.
Table 5-4: Control Board Fuse Specifications
Fuse Description Size
Aerotech
P/N
Third Party P/N
F1 Control Power at +24V Input 2 A S.B. EIF01066 Littelfuse 0473002.MRT1L
F2 Motor Power at DC+ Input 5 A S.B. EIF01061 Littelfuse 39215000440
iXC2/XC2 Hardware Manual
86 www.aerotech.com