Aerotech AGV-14 HP, Руководство по оборудованию, Страница: 45 / 66

2.5. Air Requirements
WARNING : To prevent damage to the AGV-HP(O), do not attach a water hose to an air
fitting or an air hose to a water fitting.
DANGER : High pressure air can cause severe injury.
l
Lock out the source and bleed off the pressure before you do service to the equip-
ment.
l
Wear eye protection.
An air supply is needed for AGV-HP(O) models equipped with the -AC air cooling option. A gas supply
pressure of 517 kPa to 586 kPa (75 psi to 85 psi) is required when using this feature. Gas must be
delivered through a polyurethane air hose with an outer diameter (OD) of:
l
AGV-HP: 6 mm OD (4 mm ID)
l
AGV-HPO: 4 mm OD (2 mm ID)
Unless otherwise specified, a gas flow rate of 20 SLPM (standard liters per minute) at 550 kPa (80 psi)
should be observed.
l
If nitrogen is used, it must be 99.99% pure and filtered to 0.25 microns. [Recommended]
l
If compressed air is used, it must be filtered to 0.25 microns, dry to 0º F dew point, and oil free.
The filtration requirement is necessary to prevent particles from damaging the optical surfaces of
the turning mirrors.
Figure 2-17: Air-Cooling (-AC) Locations
AGV-HP(O) Hardware Manual 2.5. Air Requirements
www.aerotech.com 45