7
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
Follower
holding wrong at
the top of the pin
strip.
Slide follower holder gently
to the bottom and release
to reset the pin strip in the
magazine.
Jammed
fasteners
Clear jam according to
User Manual.
SYMPTOM 3
Operation of the tool is not stable.
Possible
reasons
Services
Fuel Cell is low.
Replace fuel cell according
to User Manual.
Spark Plug wire
is loose.
Contact authorized ser-
viceman for repair.
Filter
element is dirty,
causing tool to
overheat.
Remove fi lter
element and clean accord-
ing to User Manual.
Tool sleeve or O-
Rings are dirty.
Contact authorized ser-
viceman for repair.
SYMPTOM 4
Unstable performance.
Possible
reasons
Services
Built-up dirt and
debris
inside cylinder
Contact authorized ser-
viceman for repair.
SYMPTOM 5
Diminishing power.
Possible
reasons
Services
Damaged piston
or cylinder.
Contact authorized ser-
viceman for repair.
E. Returning/Purging Stage of
Operation
SYMPTOM 1
Tool operated and drove fastener, but piston did
not return to up position.
Possible
reasons
Services
Mushrooming of
Piston Tip.
Contact authorized ser-
viceman for repair.
Exhaust ports on
the sleeve are
dirty or clogged
Contact authorized ser-
viceman for repair.
Tool (Sleeve) or
O-Rings are dirty.
Contact authorized ser-
viceman for repair.
SYMPTOM 2
Combustion Chamber does not drop after tool
cycles.
Possible
reasons
Services
Contact arm is
bent, or tool is
dirty.
Clean tool or replace con-
tact arm as require
