AEROSMITH CONCRETE GAS TOOL OPERATIONAL MANUAL
2
the battery.
2. To install the battery, insert the battery
cartridge until hearing a “click”.
3. To remove the battery, grip the buttons on
both side of battery cartridge and pull out.
C. Battery Light Indicator
LED
Battery Level
All LEDs
100%
1 Green and 1 Red
LED
50%
1 Red LED
25%
NOTE:
•
After using the tool, remove the battery from
the tool to prevent the tool from being fi red.
D. Preparing the fuel cell
Caution !
•
Never attempt to use fuel cell from other
manufacturer.
•
Do not remove the cap when it is unused.
•
Never drill a hole on the fuel cell.
•
Do not inhale the gas. Breathing in the gas
could cause sleepiness, dizziness or nausea.
•
The fuel cell is not refi llable, do not attempt
to refi ll the gas.
Steps:
First ensure to use the corect colour valve, Please
refer to the technical specifi cations.
1. Detach the cap, attach the valve by pushing
A. Charging
Steps:
1. Plug the battery charger into the proper AC
voltage source, green light will be flashing.
2. Insert the battery into charger, red light will
alight indicating the battery is charging.
3. It takes about 60 minutes for charging.
4. When fully charged, green light will remain
alight.
5. After charging, unplug the charger from the
power source.
•
If orange light is blinking, remove the battery
cartridge and plug again.
•
If this happens continuously, the battery
cartridge or charger may be damaged.
Consult authorized serviceman for
replacement of new battery cartridge.
NOTE:
•
Never attempt to open the charger or battery
cartridge.
•
The battery charger is for charging specifi c
battery pack. Never attempt to charge battery
pack from other manufacturer’s battery
cartridge. Unsuitable battery cartridges may
cause fi re that causes injury.
•
When the battery charger is being used,
keep out of direct sunlight.
•
To get better cooling effect, keep the exhaust
area clean.
B. Installing and removing the battery
Steps:
1. Empty fasteners from the magazine and
make sure the trigger is not pulled while installing
1 - OPERATIONS
