15
10. Remove the remaining top surface battens except for the two innermost battens.
11. Detach the bottom front wires at the nose plate.
12. Fold the wings all the way towards the keel pulling the sail over the top of the leading edges. At each
wingtip, remove the tip cover bag. Install the protective pad over the rear wires junction bolt at the rear
end of the keel tube (fig. 34).
13. Remove the kingpost from the kingpost mount. Lay the kingpost down against the keel. Install
protection bags on the top and on the bottom of the kingpost (fig. 35).
Figure 34 Figure 35
Figure 36 Figure 37
14. Using the root batten wire loop lower
the front end of the root batten from the keel tube (fig. 36).
15. Install the control frame apex protection pad (fig. 37).
Figure 38
16. Install the keel tube extension protection bag
(fig. 38).
