9
4.
If you suspect the spray tip or hose is clogged or that pressure has not been fully relieved after following the steps above,
VERY SLOWLY loosen tip guard retaining nut or hose end coupling to relieve pressure gradually, then loosen completely.
Clear hose or tip obstruction.
5.Engage trigger safety lock on gun if unit is being shut down or left unattended.
Opearating Instructions
BEFORE STARTING
(1)CHECK
all fittings and connections in the pump system, hose, and gun to ensure that they are tight.
CHECK
to ensure that there is a spray tip in the gun, and that the tip is the correct size for the coating
you are to spray. (There are various tips available, for each type of coating or configuration.)
(2) MAKE SURE
the power source is securely grounded and match the motor rating of your sprayer.
(3) New spray
: Oil is used by the factory for testing and protection. It is necessary to flush unit before
spraying. Clean the pump with warm soapy water, Make sure the hydraulic oil in the pump is clean and
sufficient in volume then begin the following procedure
1
. Remove spray tip from gun
2
. Put the input hose and pressure relief tube into the bucket with some water,
3
. Turn on the motor and push the pressure valve upright. In a few seconds, water will begin to flow up through the tube
and flow out from outlet valve, tighten the outlet valve deasil, then tighten the pressure valve deasil.
4
. When the pressure reaches up to around 207bar, check if there is any leakage on the outlet hose, if it
’s leak, Please
check.
Don’t stop or deflect leaks with your hand, body, glove or rag.
5
. If does
n’t leak, open the spray gun and have a testing spray. Clean the oil in pump. Change the soapy water and use
clean water when the spray is clean
6
. Turn off power, Continue to spray till no water out.
7
. Unlock trigger lock. Put the pressure valve upright, till no soapy water in pump
Operation
Setup
WARNING
Make sure sparayer is turned off and unplugged from power source.
Connect Gun to Sprayer
1. Connect supply hose to sprayer fluid outlet.
2. Connect other end of supply hose to gun swivel. Use wrenches to tighten all connections securely.
Installing tip and guard on gun
WARNING
1. If equipment has recently been operated, Relieve pressure.Set trigger lock
2. Using a pencil or similar object, Insert seal into back of guard.
3. Install guard over end of gun
4. Insert tip in guard.Tighten retaining nut.
Operation Spraying
1. Unlock trigger lock
2. Be sure the tip faces forward spray.
3. Hold gun perpendicular and approximately 12 inches (304mm) from surface. Move gun first, Then pull gun trigger to spray
a test pattern.
4. Slowly increase pump pressure until coverage is uniform
