www.aeroplusrc.com
Aero Plus RC Copyright 2013 © All Rights Reserved
Unpacking
Carefully unpack the model making sure to cut any covering on the model if using a sharp knife.
Inspect each item to make sure no transit damage has occurred. If you are not happy with any part or
are unsure, please contact the Dealer that you purchased from.
Covering
Due to the model spending time in different climates on its way from factory to you, some of the
covering may have wrinkles. We highly recommend that you take time to re-seal all covering edges with
an iron and to use a heat gun to remove any wrinkles and re-tighten the covering. It is best to do this
now while the plane is not assembled.
Note:
Do not let any heat get near parts like the canopy or cowl as this may cause damage.
Assembly Tips
We also recommend that you go over all the major accessible joints with some C.A. glue. Also
wick thin C.A. glue into areas of high stress around the U/C plate and motor box.
Use a thread locker on all metal-to-metal joints. Even if you are using electric with low vibration
levels it will make sure that things do not drop off your airplane!
