www.aeroplusrc.com
Aero Plus RC Copyright 2013 © All Rights Reserved
Cut out the area for the engine cylinder head and the exhaust outlet on a piece of thin card and
tape this to the fuselage at one end.
Remove the engine and fit the cowl, then fold the card back over.
Mark the area and cut out using a dermal. Ensure that enough air can get out of the cowl. The
ratio is usually three times out to one in.
Fit the ignition on the side of the motor box. Use Velcro and a strap to ensure it does not come off
with vibration.
The cowl is fixed in 4 places, 2 at the top and 2 at the bottom. Place masking tape over the bottom
2 and pierce where the blind nut hole is.
Refit the cowl and drill where the marked hole was.
The fuel tank is pre-installed. Attach petrol proof pipe as per labelling on tank
Use the supplied pushrod with a ball joint to connect to the throttle arm on the engine. Then find a
convenient place to locate the throttle servo using the supplied mount.
