9
•
press the sail to the tip with clamp wall (be sure there are no wrinkles on
the sail between clamp wall and tip)
2.9. Put out the tip tube, fold down the tip strut as much as possible and put
the tip strut’s free end on the pin on the trailing edge. The tip strut side
edge must be under the angle on the tip rib’s bracket.
2.10.Lock the tip strut, connect top and bottom sail each other
2.11.Repeat steps 2.6 through 2.8 for another side
2.12. For one side at a time:
•
Set ribs to the trailing edge (don’t lock on center yet). Hook rubber of
the ribs wire to the ribs wire holding bracket. Make sure that each rib
end is properly installed into the trailing edge tube. The tube must be
placed between the limiting plates on the rib fork (end)
