Aerola Alatus-M, Руководство пользователя

Страница: 17 / 36

ALATUS-M – Owner’s Manual
16
5.1.9. Attach the right strut (R) installing the Ball Lock Pin into the wall bracket then moving
the wing back and forth matching the strut with the tail beam plate. Install the tapered
pin and lock it by the still ring. Repeat all steps on the other side the same way. Make
sure that the control cable and the rib cable routes ABOVE the strut.
5.1.10. Remove the Velcro around the D-Cell and carefully pull the sail over the D-Cell. Go
to the wingtip. Reach inside the sail and locate the wire (red) that’s attached to the rib
safety cable. Pull that cable out of the sail and hook the loop of bungee over the tip pin
at the end of the D-Cell. Push the ribs into contact with the Trailing Edge Tube. Be
sure that they are properly aligned so the sail doesn’t get damaged. The bungee
tension should hold them nicely in place. Verify that the ribs are aligned properly,
connect the rib safety cable to the bracket located on the wall of the D-Cell.