Aerobotics AeroHawk, Руководство по эксплуатации самолета

Страница: 8 / 15

Installing the Battery
The following procedure is to be followed before each flight. After the flight, batteries should be disconnected and
removed from the AeroHawk for transportation.
3. Place the battery into the battery compartment by
sliding it in above the Velcro and then pressing
down to secure it to the Velcro (Note: you might
have to shift the battery forward or back to ensure
the AeroHawk’s center of gravity is correct, see step
4). Ensure that the battery is secure so that there
will be no relative motion in-flight.
4. Getting the center of gravity of the AeroHawk
correct is extremely important to ensure a good
flight. Place your fingers on the CoG marker (a
sticker or a small bolt) under the wings. The
AeroHawk should balance level or at most 5
degrees nose down. If not, move the battery forward
or back and try again.
1. Power on the radio controller. Ensure that all
switches are in the up position and that the
Throttle & Rudder Control stick is in the down
centre position (See Radio Controller
schematic).
2. Open the front compartment by pushing the
latch towards the nose and lifting it up at the
same time.