aero-naut TRIPLE SPEED R.E.S. THERMIC, Инструкция по эксплуатации

Страница: 18 / 40

1
2
For the next building steps place the wing panel in the Depron building jig as shown to
guarantee correct alignment of parts.
Place Depron jig on building board and secure with tape or pins. Then place the components
you have just built as well as trailong edge sheeting TR-05 in the jig as shown.
3
TR-02
TR-03
TR-05
TR-01
Attention: Make sure you build a left and a right wing panel. In this section construction of one wing panel is described. Build the opposite
wing panel accordingly.
Section V - Triple R.E.S. Wing
Use a razor saw to cut out the aileron and carefully sand sheeting material flush with riblets on either side. Glue TS-39 to front of
aileron and bevel off to allow for sufficient control throw. After covering attach aileron to wing with tape.
Tip:
If you do not want to use tape, you can bevel off top and bottom of TS-39 and use small hinges to attach the aileron to the wing.
TS-39
19
Triple
speed
Protect building board with cling film. Place two parts
TR-01 on building board as shown and secure with
pins.
Glue spruce strip TR-02 (2 x 8 mm) to TR-01 and cut off
flush with sheeting material on either side. Make sure
to build a left and a right wing panel!
Position main spar TR-03 exactly in the
middle of TR-02 and glue in place.
Wing joiner part TR-04 will be glued in
place after ribs have been placed.
18 19