aero-naut TRIPLE SPEED R.E.S. THERMIC, Инструкция по эксплуатации

Страница: 13 / 40

Protect building board with cling film. Place two parts TS-01 on
building board as shown and secure with pins.
Glue spruce strip TS-02 (2 x 8 mm) to TS-01 and cut off flush with
sheeting material on either side. Make sure to build a left and a
right wing panel!
1
Attention: Make sure you build a left and a right wing panel. In this section construction of one wing panel is described. Build the opposite wing
panel accordingly.
TS-01
TS-01
TS-02
TS-02
TS-03
Position main spar TS-03 exactly in the middle
of TS-02 and glue in place.
Wing joiner part TS-04 will be glued in place
after ribs have been placed.
For the next building steps place the wing panel in the Depron building jig as shown to guarantee correct alignment of parts.
Place Depron jig on building board and secure with tape or pins. Then place the components you have just built in the jig as
shown.
2
3
Enlarged view of main
wing spar, glued on
place on TS-02.
Section IV - Triple speed Wing
Place two-piece trailing edge sheeting TS-05 and TS-07 as well as
aileron sheeting TS-06 in the jig as shown.
Fit ribs TS-09 to TS-25 in place in numerical order. Root rib TS-08 will be fitted at a later
stage. Make sure you position ribs exactly at right angles in relation to spar, then glue in
place. Note, that ribs are glued to spruce spar, main spar, trailing edge sheeting and aileron
sheeting. Do not apply glue to front part of ribs between wing spar and leading edge
position.
4
5
6
TS-05
TS-07
TS-06
Glue in place aileron riblets TS-26 and TS-
27 on either end of aileron.
7
Glue in place TS-04 together with rib TS-08. Make
sure TS-08 is slightly angled in accordance with
dihedral of wing.
TS-26
TS-08
TS-27
TS-04
TS-03
TS-04
TS-08
TS-03
Note: Root rib TS-08 will be gleud in place together with
TS-04. TS-04 determines the correct dihedral angle for the
root rib.
12 13