aero-naut Canadair CL-415, Инструкция по сборке

Страница: 12 / 13

Canadair CL-415
12
Part Description No. Material Size in mm
No. off
Nut 6 Brass M2.5
Nut 10 Brass M2
Nut 2 Steel M4
Washer 5 Brass 3.2 / 7 Ø
Collet, complete 5 Steel 3 / 6 Ø x 5 mm
Cheesehead screw 10 Nylon M4 x 30 mm
Cheesehead screw 2 Nylon M5 x 50 mm
Pushrod connector 2 Steel 4.5 x 2 Ø x 10 mm
Pushrod connector 2 Steel 6 / 2 Ø x 9 mm
Aluminium sheet 1 Aluminium 8 x 1.5 x 120 mm
Aluminium sheet 2 Aluminium 8 x 1 x 130 mm
Brass sheet 1 Brass 30 x 26 x 0.3 mm
Cable 1 + 1 Red / black 0.75 mm², 600 mm long
Cable 1 + 1 Red / black 1.5 mm², 125 mm long
ABS sheet 1 Plastic 225 x 100 x 1 mm
Decal sheet 3
Plan 2
Building instructions 1
As plan: see plan for dimensions, or measure from model.
The following extra items are required to build the model:
Ponal Express Order No. 7638/10 Laminating resin (low-viscosity)
Stabilit-Express Order No. 7646/01 Thixotropic additive (for thickening
Pattex cyano-acrylate Order No. 7639/21 laminating resin)
Pattex gel cyano Order No. 7639/25 Soft binding wire, hinge tape
Plan text - Canadair CL-415
1
View D
2 View G
3 Aluminium strap, 37 x 8 x 1.5 mm
4 Cut openings with fretsaw or similar
5 Schematic view only of parts (11) and (12)
6 Section J-J
7 Fuselage side guide sleeves from part 20 - see building instructions
8 Bind tightly with soft binding wire, solder joint securely
9 View C
10 Rudder servo installation (R.H. fuselage side)
11 Section C-C
12 Section D-D
13 Section E-E
14 Cut away GRP
15 Scrap 2 mm balsa
16 These parts factory-fitted in the fin
17 Cut tailplane opening carefully - see building instructions
18 Glue fin to stub fin - see building instructions
19 Section F-F
20 Section G-G
21 Rudder pushrod slot
22 Elevator pushrod slots
23 Section H-H
24 View E
25 Wheel axle
26 Solder washer
27 Solder collet
28 Make from brass sheet - see building instructions
29 Section A-A