AERMEC HBI 080, Руководство по установке, Страница: 14 / 45

14
HBI. 1011. 4138500_00
Unit installation must be in compliance
with local and national safety codes.
Do not install the unit alone.
Contact your dealer after the machine
has been purchased.
Professional installers will perform installa-
tion and insertion in compliance with that
stated in the installation manual.
Do not connect electric plugs until the
installation jobs have been completed.
Follow the wiring diagrams supplied with
the equipment and shown in this docu-
ment when making the connections.
The unit is built with materials treated to
resist weather and therefore does not
have to be particularly protected.
Basamento
Raccordo di scarico
in order to prevent the noise produced from
normal functioning entering the room.
The outdoor unit must be installed in the open, perfectly
horizontal, on a stable and solid support, respecting
minimum technical spaces in order to allow the pas-
sage of air and any maintenance to be performed.
Installation
• in the open
• perfectly horizontal,
• respecting
minimum technical
spaces in order to
allow the passage
of air and any
maintenance to be
performed
Check that the heat exchange coil is not
exposed to the danger of hail.
Do not position the outdoor unit
under the window
Do not position the outdoor unit
between two buildings
The condensate produced in the heating functioning
mode can be conveyed to a drain making use of the
relevant set-up.
Do not install in places where inflammable or explosive
products are found.
If the unit is to be fixed to a wall, use brackets with suit-
able dimensions for supporting the weight of the unit.
Use M12 bolts to tighten the feet and the sub-frame during
installation.
Base
Discharge fitting
8. GUIDE LINES FOR INSTALLATION OF THE OUTDOOR UNIT
the image is purely indicative