GETTING STARTED
1. Place the VIDIUS HD on a flat LEVEL surface and turn drone power on.
2. Turn the controller on by sliding the power switch to the left.
3. Power Indicator light will begin flashing, indicating it is ready to pair.
4. Move left joystick UP (Figure 1) short beep, then DOWN (Figure 2) long beep.
5. Lights on both the VIDIUS HD and the Controller will remain solid.
6. Your VIDIUS HD and Controller are now paired and ready for flight!
AERIX
Begin each flight with a fresh calibration.
After pairing is complete, leave the drone on a flat, level
surface and hold the joysticks as shown.
Drone lights will blink, hold until lights are solid.
Drone is now successfully calibrated for flight.
Once ready to begin flight, hold the joysticks as shown
to start the motors, press and hold the left joystick UP to
takeoff and release when at a desired height.
In case of an emergency or upon landing, you can stop
the blades from spinning at any time by holding the
joysticks as shown. Follow directions above to re-start.
CALIBRATE DRONE
START MOTORS
STOP MOTORS
