Aerial HF2 Series, Инструкция по эксплуатации

Страница: 11 / 17

MAINTENANCE AND SERVICE
Page 8 of 11
6 Maintenance and service
Filter change
CAUTION
Damage to the device
Cleaning agents can cause damage to surfaces.

Use only mild detergents.
The cleaning intervals depend largely on the operating conditions. Therefore
check your HEPA filter HF2 after each drying operation.
In order to guarantee trouble-free functioning of the device it must be regularly
cleaned, and in particular the prefilter and the HEPA filter must be checked at
regular intervals. To change the filter proceed as follows:
1
HEPA
filter
2 Prefilter
Fig. 3: HEPA filter and prefilter

Open the two tension locks on the front and rear sides. Remove the cover
from the housing bottom part.

Pull the HEPA filter out of the housing bottom part, and insert new HEPA
filter or prefilter (see fig. 4 and 5 on the next page). Use only original filters
to guarantee proper functioning of the HEPA filter HF2. The prefilter is
fastened around the HEPA filter with Velcro (see fig. 3).

Clean casing on the outside with a moist cloth.