Using a 2.5mm Hex bit remove the (qty 4) Nose Cone Bolts.
Using a Phillips Screw driver remove the
(qty 2) Phillips screws below the Gimbal Vibration Damping Bracket.
Gently remove the Nose Cone of the Inspire 1.
Once the Nose Cone has been removed, insert the red and black Power Plug of the FPV
Wiring Harness into the open port of the Inspire 1.
Run the Power Leads under the Cables to the right to keep them tight, safe and away from the Compass.
Reattach the Nose Cone using all (qty 4) 2.5mm Bolts as well
as the (qty 2) Phillips Screws. Run the FPV Camera Lead down through the front of the Inspire 1.
Controls for the FPV monitor:
Power On and Off: Press and hold power button (approximately 3 seconds)
Menu: Press power button.
Select: M
Back / Return: Power
Change in Menu: up/down
Change Channel: -/+
FPV Monitor Band and Channel Change:
1. Press and hold power button (approximately 3 seconds) to power On the monitor.
2. Press power button twice, rapidly to access menu.
3. Press the down arrow until you reach the RF menu (Small T.V.).
4. Press M to enter menu. (Ensure Diversity Band, Rx1 band, and Rx2 band are all on the same band).
5. Press M again to select the band.
6. Press up or down to change the band.
7. Press power button to go back.
8. Repeat steps 4-7 till all bands are the same.
9. Press power button to go back and exit the menu.
10. Change channel with the -/+ Button.
(Recommended Band and Channel: Band A Channel 1)
Changing Video System (Monitor):
1. Press power button twice, rapidly to access menu.
2. Press the down arrow until you reach the Function menu (Crossed Tools).
3. Press M to enter the Function menu.
4. Press the down arrow until you reach Video System.
5. Press M to select the video system.
6. Press the down arrow to select NTSC or PAL.
Black Pearl FPV Monitor setup
