A
E
R
A
A
I
R
I
N
N
O
V
A
T
I
O
N
13
Installation
Transportation & Storage
Transportation
All heat recovery devices manufactured by AERA are
passed through all tests and controls and shipped
from the factory. Appropriate lifting methods should
be used to prevent damage to the heat recovery
devices during vertical or horizontal transportation.
Transpallets or forklifts can be used to carry and lift
these devices. During lifting and transportation, the
appliance must be secured and safety measures must
be taken for safety. Lifting and carrying should be
done by trained and experienced personnel. Ensure
that the weight is uniformly distributed across the four
corners during carry of the devices.
Storage
All heat recovery devices manufactured by AERA
are located in a place after shipment If storage is
required, close all openings to avoid contamination.
The environment in which the heat recovery device is
stored should have minimum temperature of -20 ° C,
maximum temperature of + 40 ° C and maximum of
80% relative humidity. It must be stored in a closed
box away from dust and moisture to avoid damaging
the devices. Prevent the electrical components and
components from being damaged when performing
the packaging of the device. Accessories such as
filters, must be packaged separately to avoid exposure
to dust and moisture.
Before connecting the ducts, check that no sawdust or any other foreign material
(scraps of paper, vinyl, building material etc.) exist in the ducts.
Do not touch the damper clamp (plate) inside the unit when connecting to ducts
as it may cause malfunctioning of the by-pass system.
Do not install the ducts as shown on the following figures. Doing so will increase
the pressure drop, decrease the air volume from the unit and give rise to abnormal
sounds.
Steep
turn
Multiple
elbows
Elbow
after
unit
Sudden contraction
and/or
expansions
in duct diameter
