AEQ
NETBOX 32 AD / NETBOX 8 AD / NETBOX DSP
Audio over IP multichannel interfaces
17
When connecting the USB module to a PC through the USB port, the PC automatically
recognizes it as a new audio device (identified as "USB Audio CODEC"). Audio can be sent to it
from any playback program, like with any other professional external soundcard. Also, audio
can be recorded from NETBOX by using any recording application. The card is "plug&play" on
Microsoft Windows™ operating systems and Apple Computer Mac OS™, not requiring any
special driver.
The supported sampling rates are 32 KHz, 44.1 KHz y 48 KHz, with internal Sample Rate
Converter (SRC) to the 48 KHz frequency used internally by the DANTE-based AoIP AEQ
system.
2.2.2.3.1. Digital inputs/outputs jumpers configuration.
IMPORTANT NOTE: Access and configuration of the configuration jumpers require a previous
experience in installing and configuring computer or electronic cads. Don’t open the unit if you
lack this experience in order to avoid risk of electrical shock or damages to the system.
Digital inputs and outputs are programmed by default as AES/EBU. If compatibility with
SPDIF equipment is required, you must open the unit and change the corresponding
configuration jumpers.
-
Opening the unit.
It’s VERY IMPORTANT to turn first the equipment off and disconnect the power supply
cable. Remove the 3 screws located at the top of the rear panel and the 3 one located
at the front of the unit’s base. Pull up from the top cover and remove it.
-
Finding the jumpers location.
Place the unit with the front facing towards you and recognize the following zone inside
it:
DIGITAL
INPUTS
AND
OUTPUTS PROGRAMMING
ZONE
