Aeotec Nano Switch, Руководство пользователя

Страница: 17 / 18

15 18
After your Nano Switch is installed and powered
on, you are now able to manually control the Nano
Switch to turn it On/Off directly via pressing your
Nano Switch’s Action Button, it is time to add your
Nano Switch to the Z-Wave network. To set your
Z-Wave gateway/controller into pairing mode, please
refer to the respective section within your controller
instruction manual.
3
Adding your Nano Switch to a Z-Wave
network.
Quick start.
Set your Z-Wave controller into pairing mode.
Press the Action Button on the Nano Switch or
toggle the external manual switch once, the green
LED (non-secure indication) will blink to indicate
the Nano Switch is entering into pairing mode. 1.
2.
You can also set the external switch mode through
Configuration Command Class.
Parameter 120 [1 byte dec] is the parameter that
will set one of the 3 different modes. If you set this
configuration to:
(0) 2-state switch mode
(1) Momentary push button Mode
(2) 3-way switch mode
switch wired into Nano Switch, toggle the button on
the manual switch once and wait 2 seconds for the
Nano Switch to detect the type of manual switch.
Touch panel control.
As you can see that the Nano Switch’s surface has
a pin port, this port is used to connect the Touch
panel. When you have already connected it to the
Nano Switch, you will be possible to control the