AENO ASC0001, Руководство пользователя

Страница: 10 / 116

10 aeno.com/documents
dustbin housing counterclockwise (see picture e). Pull out the MIF filter
with its holder by pulling the loop labeled "UP". Clean rubbish from the
dustbin housing, holder and MIF filter. Rinse the MIF filter and its holder in
running water and dry. After that, insert the MIF-filter into the holder, insert the
holder into the body of the dustbin housing and screw the cap.
The main brush
and the roller inside it require regular cleaning of trapped
hair and other rubbish. To remove rubish, remove the roller from the brush
housing. To do this, pull out the brush lock located on the right side. Push back
the brush retainer latch and pull the roller out of the slot. Do not clean the roller
with your fingers, use only special brush. Do not wash the roller with water or
cleaning detergents.
Troubleshooting
The vacuum cleaner does not turn on. Possible causes: low charge level,
clogging. Solution: charge the battery, clean the clogs.
Weak suction power. Possible causes: overfilled dustbin, clogged brush.
Solution: clean the dustbin, filters and the brush.
Strong noise, extraneous sounds. Possible causes: clogged metal extension
tube. Solution: clean the tube.
The main brush roll does not rotate. Possible causes: clogging. Solution:
disassemble the main brush, remove the roller and the clog.
The LED indicator lights up blue, then it starts blinking red and the cleaner
shuts off. Possible causes: the battery has overheated or overcooled because
the room temperature is too high or too low. Solution: use the vacuum cleaner
at temperatures between 0 °C and +40 °C.
While charging, the LED indicator lights up red. Possible causes: non-original
power adapter is used, the battery is out of order. Solution: Use only the original
power adapter to charge the vacuum cleaner.