AEMC Simple Logger CL600, Руководство пользователя

Страница: 13 / 20

RMS Clamp-on Simple Logger® Model CL600
11
CHAPTER 5
MAINTENANCE
5.1 Battery Installation
Under normal conditions, the battery will last up to a year of continuous
recording unless the logger is restarted very frequently.
In the OFF mode, the logger puts almost no load on the battery. Use the
OFF mode when the logger is not in use. Replace the battery once a year
in normal use.
If the logger will be used at temperatures below 32°F (0°C) or is frequently
turned on and off, replace the battery every six to nine months.
1. Make sure your logger is turned off (no blinking light) and all
inputs are disconnected.
2. Turn the logger upside down. Remove the battery cover by
removing the slotted screw.
3. Locate the two-wire (red/black) battery connector and attach the
9V battery to it. Make sure that you observe polarity by lining up
the battery posts to the proper terminals on the connector.
4. Once the connector is plugged onto the battery, insert the battery
into the battery compartment.
5. If the unit is not in record mode after installing the new battery,
disconnect it and press the button twice then reinstall the battery.
6. Place the battery cover over the compartment, being careful not
to pinch the wires, and screw into place.
Your logger is now recording (LED blinking). Press the PRESS button for
five seconds to stop the instrument.
NOTE: For long-term storage, remove the battery to prevent discharge
effects.
5.2 Cleaning
The body of the logger should be cleaned with a cloth moistened with
soapy water. Rinse with a cloth moistened with clean water. Do not use
solvent.