DC/AC MicroProbe Models K100 and K110
23
5. MAINTENANCE
WARNING
Please make sure that you have already read and fully understand the
Precautions for Use in Section 1.1.
• To avoid electrical shock, do not attempt to perform any servicing
unless you are qualified to do so.
• To avoid electrical shock and/or damage to the instrument, do not get
water or other foreign agents into the case. Turn the Model K100/K110
OFF and disconnect the unit from all circuits before opening the case.
5.1 BATTERY INSTALLATION
Your Model K100/K110 has been shipped with a new 9 V battery installed.
To replace the battery:
• Remove probe from any conductor and place it away from any active
conductors, circuitry, etc.
• Unplug electronic module from display device (e.g. DMM,
oscilloscope).
• Remove the screws from the bottom cover of the electronic module.
• Replace battery with a new 9 V alkaline type.
• Replace bottom cover and re-attach with screws.
SCREWS
BATTERY CLIP
RATING
300 V, IEC 1010-1, CAT.
II
BATTERY: 9 V, NEDA 1604, 6LF22, 6LR6
1
INPU
T
CURRENT : 0-4500 mA DC / AC peak
WARNING
REMOVE PROBE FROM TESTED CIRCUIT
BEFORE OPENING THE CASE
.
AEMC INSTRUMENTS, BOSTON, MA
MADE IN US
A
!
!
!
Figure 16
