Simple Logger
®
II Model CL601
17
Event: Battery Power is Insufficient for a Full Recording Duration
If the battery voltage drops below 1.7V, the following will occur:
The Recording Session will terminate.
•
The Data will be saved.
•
The GREEN and RED LED will turn OFF.
•
The logger continues to record until the battery voltage drops below 1.7V.
Pressing the
PRESS
button may not turn the unit ON at all. The battery
voltage may rise slightly after the unit turns itself off. In this event, the unit
may turn on momentarily as a result of a button press.
The batteries must be replaced before the recorded session(s) can be
downloaded from the instrument.
NOTE:
Replacing the batteries while the unit is OFF will not result in the loss
of data memory. The internal backup capacitor will maintain the clock and
memory while the main batteries are being replaced. If the battery level falls
below the usable level or if the batteries have been removed for an extended
period of time, the clock time will be lost. However, the recorded memory will
be maintained since it is stored in Flash memory.
Event: Recording Session has Ended
The logger will be in STANDBY mode if one of the following occurs:
The session terminates due to recording end time being reached.
•
The recording in START/STOP mode fills the memory.
•
The user terminates the session by pressing the
•
PRESS
button
until the STOP (ORANGE) LED lights up and releasing the button
before the next LED lights, or issues a Stop Recording command
from the Simple Logger
®
II Control Panel.
Under these conditions, it is possible to turn the logger ON from the
computer to download the data, if the batteries have sufficient power.
The logger is now ready for a New Session or Download. Pressing the
PRESS
button until the START (GREEN) LED lights up and releasing the
button before the next LED lights, will start a New Session depending on
the available memory.
www.
ShopAEMC
.com
Shop for AEMC products online at:
1.888.610.7664
