AEMC 6526, Быстрый старт

Страница: 6 / 16

6 Megohmmeter Models 6526 & 6534 - Quick Start Guide
PRECAUTIONS FOR USE
This instrument is compliant with safety standard IEC 61010-2-030, and the
leads are compliant with IEC 61010-031, for voltages up to 600 V in CAT IV or
1000 V in CAT III.
Failure to observe the safety instructions may result in electric shock, fire,
explosion, destruction of the device, or destruction of the installations.
■
Carefully read and understand all precautions for use.
■
Be aware of all electrical hazards when using this instrument.
■ Using this instrument other than as specified may compromise the
instrument’s user protection features.
■
The safety of any system in which this instrument is incorporated is the
responsibility of the integrator of the system.
■
This instrument can be used on CAT IV installations, for voltages not
exceeding 600 V
RMS
with respect to ground or 700 V
RMS
maximum between
terminals.
■
Do not use the instrument on networks whose voltage or category exceeds
those specified in this manual.
■
Observe all environmental conditions of use.
■ Except for voltage measurements, take no measurements on electrically “live”
systems.
■
Do not use the instrument if it appears damaged, incomplete, or poorly closed.
■
Before each use, check the condition of the insulation on the leads, housing,
and accessories. Any part on which the insulation is deteriorated (even
partially) must be set aside for repair or scrapping.
■
Using the instrument without its battery compartment cover may result in
electric shock to the user.
■
Before using your instrument, ensure it is completely dry.
■
Use only the leads and accessories supplied. The use of leads (or other
accessories) of a lower voltage rating or category limits the use of the
instrument/leads (or accessories) combination to the lowest category and
service voltage.
■ When handling the leads, test probes, and alligator clips, keep your fingers
behind the physical guards.
■
Before removing the battery compartment cover, ensure all measurement
leads and accessories are disconnected. Replace all batteries at once. Use
alkaline batteries.
■
Use personal protection equipment where appropriate.
■
All troubleshooting and metrological checks must be done by competent,
accredited personnel.