AA95-766 Single Channel Audio Controller
SM95-766 Installation and Operation Manual
June 20, 2012 Rev: 3.00
Page 2-1
ENG-FORM: 805-0100.DOTX
CONFIDENTIAL AND PROPRIETARY TO ANODYNE ELECTRONICS MANUFACTURING CORP.
Section 2.0 Installation
2.1 Introduction
Information in this section consists of: unpacking and inspection procedures, installation procedures,
post-installation checks, and installation drawings.
2.2 Unpacking
and
Inspection
Unpack the equipment carefully. Inspect the unit visually for damage due to shipping and report all such
claims immediately to the carrier involved. Note that each unit should have the following:
- AA95-766 Single User Audio Controller
- Product Information Card
- Certificate of Conformity
Verify that all items are present before proceeding and report any shortage immediately to your supplier.
2.2.1 Warranty
All Anodyne Electronics Manufacturing Corp. (AEM) products are warranted for 2 years. See the website
www.aem-corp.com/warranty for complete details.
2.3 Installation
Procedures
2.3.1 Warnings
Do not bundle any lines from this unit with transmitter coax feed lines. Do not bundle any logic, audio, or
DC power lines from this unit with 400 Hz synchro wiring or AC power lines. Do not position this unit next
to any device with a strong alternating magnetic field such as an inverter, motor or blower, or significant
audio interference will result.
2.3.2 Cautions
In all installations, use shielded cable exactly as shown, and ground only as indicated. Significant
problems may result from not following these guidelines.
All audio installations can be seriously degraded by incorrect wiring and shielding, which may result in
abnormal cross-talk, hum and ground-loop noise. Be particularly careful with all microphone wiring and
tie line wiring, as these lines carry the lowest level signals in the aircraft.
