AEM 30-0311, Инструкция по эксплуатации

Страница: 7 / 9

7
30-0311 - OBD-II
Gauge Installation
Installation using supplied bracket
Installation w ithout bracket, using rubber band
A 2-1/6" (52mm) hole is required to mount the X-Series gauge. A bracket and thumbscrews are provided to facilitate
installation into a panel or gauge pod. In some cases, the gauge cup may be pushed into a mounting hole causing an
interference fit strong enough to retain the gauge; the supplied rubber band may be fit to the gauge to create a tighter fit in
mounting holes slightly larger than 52mm. It is, however, recommended that gauges be mounted securely using the
supplied bracket to ensure they never become loose and cause a hazard during vehicle operation.
Note: The gauge is not water-proof and should not be installed in a location with exposure to water or snow. Damage
caused by water ingress will not be covered under warranty.
OBD-II Parameter IDs (PIDs)
PID
(hex)
Display Label Description US SI Notes
10
A.FLo
MAF air flow rate lb/min g/sec
0F
Air.t
Intake air temp degF degC
46
Air.t
Ambient air temp degF degC
68
Air.t
Intake air temp sensor degF degC If $0F is n/a
33
bAro
Barometric pressure (abs) psi kPa
42
bAtt
Control Module Voltage V V
05
Cl.t
Engine coolant temp degF degC
23
d.Prs
Fuel Rail Pr (die or gdi) kpsi bar If $0A & $22 are n/a
59
d.Prs
Fuel Rail Pr (die or gdi) kpsi bar
6D
d.Prs
Fuel Rail Pr (die or gdi) kpsi bar
78
EGt.1
EGT Bank 1 degF degC B1S1 only
79
EGt.2
EGT Bank 2 degF degC B2S1 only
0C
E.SPd
Engine RPM rpm rpm
52
Eth
Ethanol fuel % % %
66
Flo
Mass air flow sensor lb/min g/sec FLOA + FLOB (if supp)
2F
F.LVL
Fuel Level Input % %
0A
F.Prs
Fuel pressure (gauge) psi bar
22
F.Prs
Fuel Rail Pr (rel to map) psi bar If $0A & $23 are n/a
5E
F.rtE
Engine fuel rate ga/hr liter/hr
5B
H.bAt
Hybrid Battery Charge % %
03
Loop
Fuel system status n/a n/a "OL" = Open Loop / "CL" = Closed Loop
0E
Ign
Timing advance degBTDC degBTDC -Negative sign indicates retard e.g. "-10" = 10
degATDC
0B
Int.P
Intake Manifold press (abs) psi kPa
70
Int.P
Boost pressure control psi kPa Gauge pressure
87
Int.P
Intake man abs press psi kPa If $0B is n/a
24
LA.1
O2S1_WR_lambda(1) AFR Lambda