4. Reassemble Vehicle
a.
Fender liner and splashguard:
Install the fender liner, lower splash guard and any hardware that was removed in
steps 2i through 2k.
NOTE: Failure to install the fender liner will result in diminished performance and increase the potential for
engine damage due to water ingestion in rainy conditions.
b.
Wheel:
Install the driver side wheel using the factory torque specification (see owner’s manual).
c. Position the inlet pipes for the best fitment. Be sure that the pipes or any other components do not contact any part
of the vehicle. Tighten the rubber mount, all bolts, and hose clamps.
d. Check for proper hood clearance. Re-adjust pipes if necessary and re-tighten them.
e. Inspect the engine bay for any loose tools and check that all fasteners that were moved or removed are properly
tightened.
f. Reconnect negative battery terminals and start engine. Let the vehicle idle for 3 minutes. Perform a final inspection
before driving the vehicle.
i. Check the clearance of the air filter with respect to
the surrounding surfaces. Tighten the hose clamp
on the inlet hose and the frame bolt.
h. Install the air flow sensor into the inlet pipe
utilizing the supplied screws. Plug in the air flow
sensor.
f. Install the air filter onto the end of the pipe as
shown.
g. Insert other end of pipe into the stock inlet hose.
Place mounting tab under the bolt in the frame rail.
