7
j. Install the rubber edge trim on to the heat
shield where the intake pipe passes through.
k. Install the foam rubber edge trim on to the top
edge of the heat shield. Trim excess as
necessary.
m. Install the air cleaner extension removed in
step 2b. Reconnect the breather line on the
back side. Test fit the AEM
®
intake plenum. The
plenum should not rest on the washers installed
in the previous step. Adjust the lock nuts until
the top of the plenum compresses
a
pproximately ¼” for gasket sealing. Use the
remaining washers and lock nuts to tighten
down the plenum.
l. Thread two of the supplied 5/16-18 lock nuts
on to the standoffs installed in step 3c. Leave
approximately ¾” of thread exposed above the
top of the nut. Place one 5/16” washer on top of
each nut.
