Standard
the2MicPro™
components:
STEP 1: INSTALL THE VELCRO STRAP
2
1
2.
Remove the plastic backing and apply
the velcro to the heelcap.
Note that the velcro hook strap can
be folded over to mate with the velcro loop.
This strap will be used to help secure the
gooseneck.
Durable Carry Case
.
1
3
5
4
the2Micpro
with 1/4” mono output jack
.
(1A) Mic #1 on the short gooseneck
(1B) Mic #2 on the long gooseneck
(1C) 1/4” output jack (mono)
2
EPS-2
phantom power supply adapter.
1/4” input, balanced XLR output.
3
4
Velcro Straps
with adhesive attachments for
heelcap of the guitar (3 provided).
5
3/32” Hex Wrench
(2.5mm).
Also needed but not supplied:
-A standard mono guitar cable with one
right angle (90°) plug.
-A standard XLR mic cable.
1B
1C
1A
Important Product Note:
The 2Micpro™, while easily installed or removed, is designed to remain indefinitely installed on a guitar.
With
the2Micpro™
installed, the guitar should fit easily and securely into most travel cases. This eliminates the need
to remove
the2Micpro™
after use.
If the 1/4” output jack extends too far beyond the back of the guitar, the jack may contact the bottom of the
guitar case when the guitar is stored. If the output jack does not extend enough beyond the back of the guitar, the
right angle plug of the output cable may not fully insert into the jack.
The 2Micpro™ has the capability to adjust in length to accommodate various guitar body dimensions. This
ensures that the 1/4” output jack can be set to extend beyond the back of the guitar to the proper distance. This will
be explained in greater detail on page 2 (step 3).
1.
Use scissors to trim the adhesive backed portion of the velcro
strap to match the outline of the heelcap.
Product Manual for
the2Micpro
™
1 of 4
Heelcap
